Operating Instructions – Electronic Motor DRC.-..-DAC
87
6
Startup with double slave GLK31A
Startup
6.9
Startup with double slave GLK31A
6.9.1
Startup steps
1. It is essential that you observe the startup instructions.
2. Disconnect all components from the voltage supply and use an external disconnect-
ing device to avoid unintentional re-connection.
3. Set DIP switch S2/1 to ON to activate "Expert" mode.
NOTICE
Damage to the DIP switches caused by using unsuitable tools.
Possible damage to property.
• To set the DIP switches, use only suitable tools, such as a slotted screwdriver with
a blade width of no more than 3 mm.
• The force used for setting the DIP switches must not exceed 5 N.
4. Make sure that the DRC drive unit is connected properly. Observe chapter "Electrical
Installation".
5. Place the DRC electronics cover onto the connection box and screw it on.
6. Switch on the following voltages.
• AS-Interface voltage
• Line voltage
7. Set the required AS-Interface address.
• With a hand-held programming device
• With an AS-Interface master (see description master)
INFORMATION
• Startup with the GLK31A double slave only makes sense in "Expert" mode.
• The following chapter describes the preparations made on the DRC inverter for
activating Expert mode and an example for fine-tuning parameters.
• The chapter "Parameterization and diagnostics" describes how to integrate the
DRC inverter in MotionStudio and provides an overview of all parameters with a
detailed description.
• For detailed information about the function of the double slave, refer to chapter
"Communication with AS-Interface double slave GLK31A".
2444784139
ON
DIP
1 2 3 4
S2
DIP switch S2/1 = ON
Expert mode
00
I
