Operating Instructions – MOVIDRIVE® MDR60A/61B
39
4
Conversion into an IT network unit
Installation (MDR60A0150/0370/0750 and MDR61B1600/2500)
4.5
Conversion into an IT network unit
4.5.1
MOVIDRIVE
®
MDR60A0150 size 2 into an IT system device
Proceed as follows to convert the unit into an IT network unit:
1. Loosen the 2 screws at the front of size 2.
2. Insert the 2 isolation plates into the slot until it snaps in.
3. Re-insert and tighten the 2 screws.
4. Brake the isolation plate at the pre-determined breaking point.
INFORMATION
The following applies to the MOVIDRIVE
®
MDR61B1600/2500 regenerative power
supply unit:
• For supply voltages > 480 V, set the "Enable" and "Controller inhibit" signals simul-
taneously
1.
2.
3.
4.
