2
Safety notes
Designated use
Manual – MOVISAFE
®
CS..A Safety Card
12
Specialist for elec-
trotechnical work
Any electrotechnical work may only be performed by electrically skilled persons with a
suitable education. Electrically skilled persons in the context of this documentation are
persons familiar with electrical installation, startup, troubleshooting, and maintenance
of the product who possess the following qualifications:
•
Qualification in the electrotechnical area in accordance with the national regula-
tions
•
Familiarity with this documentation
Additional qualifi-
cation
In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives, and laws specified
in this documentation. The persons must have the express authorization of the com-
pany to operate, program, parameterize, label, and ground units, systems, and circuits
in accordance with the standards of safety technology.
Instructed persons
All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the instruction is
that the persons are capable of performing the required tasks and work steps in a safe
and correct manner.
2.4
Designated use
The product is intended for installation in inverters.
The product is a programmable safety control for manufacturing safety cutoffs and
functions. The product is intended for use:
•
In emergency off devices
•
As a safety-related component pursuant to Machinery Directive 2006/42/EC
•
As a PES for risk reduction pursuant to EN 61508
•
In safety circuits according to EN 60204-1
•
As a PES for functional safety pursuant to EN 62061
•
As a SRP/CS pursuant to EN ISO 13849
•
As a device for implementing the safety functions pursuant to EN 61800-5-2
In the case of installation in electrical systems or machines, it is prohibited to start the
proper operation of the product until it is determined that the machine meets the re-
quirements stipulated in the local laws and directives.
The standards given in the declaration of conformity apply to the product.
Unintended or improper use of the product may result in severe injury to persons and
damage to property.
Technical data and information on the connection conditions are provided on the
nameplate and in chapter "Technical data" in the documentation. Always comply with
the data and conditions.
2.5
Transport
Inspect the shipment for damage as soon as you receive the delivery. Inform the ship-
ping company immediately about any damage. If the product is damaged, it must not
be assembled, installed or started up.
Observe the following notes when transporting the device:
•
Ensure that the product is not subject to mechanical impact during transportation.
24842532/EN – 04/2018
