2
Safety notes
Preliminary information
Manual – MOVISAFE
®
CS..A Safety Card
11
2
Safety notes
2.1
Preliminary information
The following general safety notes have the purpose to avoid injury and damage to
property. They primarily apply to the use of products described in this documentation.
If you use additional components also observe the relevant warning and safety notes.
2.2
User duties
As the user, you must ensure that the basic safety notes are observed and complied
with. Make sure that persons responsible for the machinery and its operation as well
as persons who work on the device independently have read through the documenta-
tion carefully and understood it.
As the user, you must ensure that all of the work listed in the following is carried out
only by qualified specialists:
•
Setup and installation
•
Installation and connection
•
Startup
•
Maintenance and repairs
•
Shutdown
•
Disassembly
Ensure that the persons who work on the product pay attention to the following regula-
tions, conditions, documentation, and information:
•
National and regional safety and accident prevention regulations
•
Warning and safety signs on the product
•
All other relevant project planning documents, installation and startup instructions,
and wiring diagrams
•
Do not assemble, install or operate damaged products
•
All system-specific specifications and conditions
Ensure that systems in which the product is installed are equipped with additional
monitoring and protection devices. Observe the applicable safety regulations and le-
gislation governing technical work equipment and accident prevention regulations.
2.3
Target group
Specialist for
mechanical work
Any mechanical work may only be performed by adequately qualified specialists. Spe-
cialists in the context of this documentation are persons familiar with the design,
mechanical installation, troubleshooting, and maintenance of the product who possess
the following qualifications:
•
Qualification in the mechanical area in accordance with the national regulations
•
Familiarity with this documentation
24842532/EN – 04/2018
