2
Safety notes
Definitions
Manual – MOVISAFE
®
CS..A Safety Card
14
2.8
Definitions
•
The designation "F-DI." stands for a safe input.
•
The designation "F-DO." stands for a safe output.
•
The designation "CS..A" is used as a generic term for all derivatives of the
MOVISAFE
®
CS product series. If a particular derivative is referred to in the
manual, then the complete designation is used.
•
The term "safe" used in this manual refers to the classification as a safe function
according to EN ISO 13849-1.
•
PROFIsafe is a technology standard for a safe fieldbus system.
•
The "Assist CS.." parameter tool is the parameterization interface in MOVISUITE
®
for the MOVISAFE
®
CS..A safety card.
2.9
Startup/operation
Observe the safety notes in the chapters "Startup" (→
62) and Operation in the
documentation.
Depending on the degree of protection, products may have live, uninsulated, and
sometimes moving or rotating parts, as well as hot surfaces during operation.
Mechanical blocking or internal drive safety functions of the product can cause a mo-
tor standstill. Eliminating the cause of the problem or performing a reset may result in
the drive restarting automatically. If, for safety reasons, this is not permitted for the
drive-controlled machine, first disconnect the product from the supply system and then
start troubleshooting.
The fact that the operation LED and other display elements are no longer illuminated
does not indicate that the product has been disconnected from the supply system and
no longer carries any voltage.
In the event of deviations from normal operation, switch the product off. Possible devi-
ations are increased temperatures, noise, or vibration, for example. Determine the
cause. Contact SEW‑EURODRIVE if necessary.
Do not deactivate monitoring and protection devices of the machine or system even
for a test run.
Additional preventive measures may be required for applications with increased haz-
ard potential. Be sure to check the effectiveness of the protection devices after every
modification.
24842532/EN – 04/2018
