2
Safety notes
Installation
Operating Instructions – MOVIFIT
®
MC
10
2.6
Installation
The units must be installed and cooled according to the regulations and specifications
in the corresponding documentation.
Protect MOVIFIT
®
from excessive strain.
The following applications are prohibited unless explicitly permitted:
• Use in potentially explosive atmospheres.
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, radiation, etc.
• Use in non-stationary applications with strong mechanical oscillation and impact
loads; see chapter "Technical Data".
2.7
Electrical connection
Observe applicable national accident prevention guidelines (e.g. BGV A3) when work-
ing on a live MOVIFIT
®
.
Perform electrical installation according to the pertinent regulations (e.g. cable cross
sections, fusing, protective conductor connection). For any additional information, refer
to the applicable documentation.
For notes on EMC-compliant installation, such as shielding, grounding, arrangement
of filters and routing of lines, refer to chapter "Installation instructions". The manufac-
turer of the system or machine is responsible for maintaining the limits established by
EMC legislation.
Protective measures and protection devices must comply with the regulations in force
(e.g. EN 60204-1 or EN 61800-5-1).
2.8
Safe disconnection
MOVIFIT
®
meets all requirements for safe disconnection of power and electronic con-
nections in accordance with EN 61800-5-1. All connected circuits must also satisfy the
requirements for safe disconnection to ensure reliable isolation.
19484828/EN – 01/2015
