6
Startup
Startup procedure
Operating Instructions – MOVIFIT
®
MC
118
6.4
Startup procedure
WARNING
Danger due to improper safety shutdown in applications with safe disconnection.
Severe or fatal injuries may result.
• If you are using a MOVIFIT
®
with the S11 PROFIsafe option, observe the permit-
ted wiring diagrams and the safety conditions specified in the "MOVIFIT
®
MC/FC
– Functional Safety" manual.
• If you are using a MOVIFIT
®
with the S12 safety option, observe the diagrams of
permitted connections and the safety conditions specified in the
"MOVIFIT
®
MC/FC – Functional Safety with S12 Safety Option" manual.
The following provides an overview of the MOVIFIT
®
MC startup procedure and lists
other applicable documentation:
[1]
5835322507
Starting up the
MOVIMOT
®
drive
→ For information, refer to:
• The chapter "MOVIMOT
®
startup"
• The "MOVIMOT
®
MM..D" operating instructions
[2]
Starting up the
MOVIFIT
®
→ For information, refer to:
• The chapter "Startup" > "General information"
• The chapter "MOVIFIT
®
on the fieldbus"
[3]
Parameteriza-
tion
1)
Programming
with
MOVITOOLS
®
MotionStudio
→ For information, refer to:
• The chapter "First steps with MOVITOOLS
®
MotionStudio"
• The "MOVIFIT
®
Function Level Classic .." manual
2)
• The "MOVIFIT
®
Function Level Technology .." manual
2)
• The "MOVI
‑
PLC
®
Programming in the PLC Editor" manual
[4]
Fieldbus
configuration
→ For information, refer to:
• The chapter "MOVIFIT
®
on the fieldbus"
• The "MOVIFIT
®
Function Level Classic .." manual
2)
• The "MOVIFIT
®
Function Level Technology .." manual
2)
1) Parameterization is only necessary in "expert mode."
2) The "MOVIFIT® Function Level Classic" and "MOVIFIT® Function Level Technology" manuals are available in several fieldbus-spe-
cific versions.
19484828/EN – 01/2015
