2
Safety notes
Designated use
Operating Instructions – MOVIFIT
®
MC
9
2.4
Designated use
MOVIFIT
®
is a component intended for installation in electrical systems or machines.
In case of installation in machines, startup of MOVIFIT
®
units (i.e. start of designated
operation) is prohibited until it is determined that the machine meets the requirements
stipulated in the Machinery Directive 2006/42/EC.
Startup (i.e. the start of designated use) is only permitted under observance of EMC
Directive 2004/108/EC.
MOVIFIT
®
meets the requirements stipulated in the low voltage directive 2006/95/EC.
The standards contained in the declaration of conformity are used for MOVIFIT
®
.
Adhere to the technical data and information on the connection requirements as provi-
ded on the nameplate and in the documentation.
2.4.1
Safety functions
MOVIFIT
®
may not perform any safety functions unless they are described and ex-
pressly approved.
For safety applications, ensure that the information in the following publications is ob-
served.
• For MOVIFIT
®
with STO (with or without S11 PROFIsafe option):
"MOVIFIT
®
MC/FC – Functional Safety" manual
• For MOVIFIT
®
with S12 safety option:
"MOVIFIT
®
MC/FC – Functional Safety with S12 Safety Option" manual
Use only those components in safety applications that were explicitly designed and
delivered for this purpose by SEW
‑
EURODRIVE. Safety-related components are
marked with the FS logo for functional safety.
2.4.2
Lifting applications
MOVIMOT
®
drives are only suitable for lifting applications to a limited degree; see the
"MOVIMOT
®
MM..D" operating instructions.
MOVIMOT
®
drives are not designed for use as safety devices in lifting applications.
2.5
Transportation, storage
Observe the notes on transportation, storage and proper handling. Observe the climat-
ic conditions as stated in the "Technical Data" sections.
19484828/EN – 01/2015
