58
Operating Instructions – MOVITRAC® B
5
General startup instructions
Startup
5
Startup
5.1
General startup instructions
5.1.1
Requirements
The drive must be configured correctly to ensure that startup is successful.
MOVITRAC
®
B frequency inverters are factory set to be taken into operation with the
SEW motor adapted to the correct power level (4-pole, 50 Hz) in V/f control mode. This
means you can start up the adjusted SEW-EURODRIVE motor without project planning.
5.1.2
Hoist applications
5.2
Preliminary work and resources
• Check the installation.
DANGER
Uncovered power connections.
Severe or fatal injuries from electric shock.
• Install the touch guard according to the regulations.
• Never start the unit if the touch guard is not installed.
DANGER
Risk of fatal injury if the hoist falls.
Severe or fatal injuries.
MOVITRAC
®
B can be used in hoist applications.
MOVITRAC
®
B is not designed for use as a safety device.
• Use monitoring systems or mechanical protection devices to ensure safety.
DANGER
Risk of crushing if the motor starts up unintentionally.
Severe or fatal injuries.
• Ensure that the motor cannot start inadvertently, for example, by removing the elec-
tronics terminal block X13.
• Additional safety precautions must be taken depending on the application, such as
monitoring systems or mechanical protection devices, to avoid injury to people and
damage to machinery.
00
I
Summary of Contents for Movitrac B
Page 2: ...SEW EURODRIVE Driving the world...
Page 259: ......
