Operating Instructions – MOVITRAC® B
137
7
List of faults (F00 – F113)
Service / list of faults
Rapid stop/warning (stop without locking)
The error response corresponds to rapid stop/malfunction but the inverter does not re-
voke the ready signal and the error output is set.
Timeout RS485 / SBus:
If the inverter is controlled via a communication interface (RS485 or SBus) and the
mains power was switched off and back on again, the enable remains ineffective until
the inverter once again receives valid data via the interface, which is monitored with a
timeout. Once the communication has been reestablished, the error message is reset.
7.1.3
Reset
Reset basic unit
An error message can be reset by:
• Reset via input terminals with an appropriately assigned digital input. DIØØ is factory
set to fault reset.
Reset keypad
An error message can be acknowledged by:
• Manual reset on the keypad (STOP/RESET key).
The STOP/RESET key has priority over a terminal enable or an enable via the interface.
The STOP/RESET key can be used for performing a reset after a fault has occurred with
a programmed error response. A reset inhibits the drive. To enable the drive, press the
RUN key.
Interface reset
An error message can be acknowledged by:
• Manual reset in MOVITOOLS
®
MotionStudio /
P840 Manual reset = Yes
, or in the
status window of the reset button.
7.2
List of faults (F00 – F113)
No.
Designation
Response
Possible cause
Measures
00
No error
–
–
–
01
Overcurrent
Immediate switch-
off with inhibit
•
Short circuit at output
•
Eliminate short circuit
•
Output switching
•
Switching with inhibited output
stage only
•
Motor too large
•
Connect a smaller motor
•
Faulty output stage
•
Consult SEW Service if the fault
cannot be reset
03
Ground fault
Immediate switch-
off with inhibit
•
Ground fault in motor
•
Replace motor
•
Ground fault in inverter
•
Replace MOVITRAC
®
B
•
Ground fault in the motor supply
lead
•
Eliminate ground fault
•
Overcurrent (see
F01
)
•
See
F01
Summary of Contents for Movitrac B
Page 2: ...SEW EURODRIVE Driving the world...
Page 259: ......
