11
6 Preparing the GSM Logger for use
6.2
Programming the GSM Logger
Each
GSM Logger
must first be programmed before it is installed at
the measurement location, i.e. data relating to measurement time,
measurement duration, etc. must be transferred from the computer
to the
GSM Logger
. The SIM data from the
GSM Logger
will be
recorded on the computer at the same time.
6.2.1
Equipment required
Programming requires the following items:
Interface
Computer with
SePem software
installed
USB cable, connector cable
A slotted nut driver for removal of the jack socket screw plug
on the
GSM Logger
6.2.2
Preparing the device for programming
Undo the jack socket screw plug on the
GSM Logger
.
Connect the
Interface
to the computer using the USB cable.
Connect the
GSM Logger
to the
Interface
using the connec-
tor cable.
Fig 6: Programming a
GSM Logger
using an
Interface
(setup)
Launch the
SePem Software
on the computer.
Preparation is now complete. The steps to be carried out on the
computer for programming the
GSM Logger
are described in the
SePem Software
operating instructions.
