10
4 SePem 100/150 loggers
4.3.3.2 Screwing on the aerial (SePem 150)
Note:
The aerial must only be screwed onto the
SePem 150
logger.
The aerial of the
SePem 100
logger is integrated in its housing.
The logger and the aerial are connected using a TNC plug-in
connector. The antenna can be screwed directly into the threaded
antenna connector.
1. Please ensure that the contacts on both the logger and the
aerial are clean and dry.
2. Screw the aerial onto the aerial connector.
Hand-tighten the aerial to ensure that the unit is sealed and
to guarantee a good radio signal.
NOTICE! Risk of damage!
There must be no mechanical stress on the internal contacts of
the TNC plug-in connector.
●
Only tighten the aerial by hand.
●
Do not use any tools.
4.3.3.3 Initial programming of the logger
Before installing the logger at the measurement location it must be
programmed, i.e. data relating to measurement times, measure-
ment duration and the radio time frame etc. must be transferred
from the
Master
to the logger. Radio contact between the two
devices must be established to carry out programming.
Note:
Each logger has to be programmed individually.