1
1 Introduction
1
Introduction
The
SePem
system is used for the early detection of leaks in
water pipe networks.
The
SePem 100
logger is ideal for mobile use as the aerial of the
logger is integrated in the housing.
The
SePem 150
logger is designed especially for stationary
operation, i.e. for use in the continuous monitoring of water pipe
networks at fixed measurement locations over long periods of
time (several years).
The
SePem 01 Master
programming and read-out unit allows the
system to be operated without the need for a computer.
SePem
is a prelocation system. Indications that a leak is present
must, therefore, always be verified using an appropriate method
(e.g. correlation).
Note:
These operating instructions describe the
SePem
system. All
descriptions refer to the system as delivered (factory settings).
The manufacturer reserves the right to make changes.
