FW3150 User’s Manual Part 1
4031
Seyeon Tech Co., Ltd
10
3. FW-3150 HW installation and basic setup
3.1. Before
installation,
z
Read carefully User’s Manual
z
Check-out if the power source is stable or not at the environment.
3.2. Factory Default Condition
The following table shows the factory default condition. Please refer to this when you need to change
the values on admin menu.
Factory Default Condition
Admin ID
root
Admin password
root
IP address
10.20.30.40
Network mask
255.255.255.0
Gateway 10.20.30.1
Table 5 : Factory Default Condition
)
Factory default Admin ID and Password are all lower case letters. You can change the password
with Capital letters.
3.3. FW-3450 Hardware installation
Following steps show the physical installation process for FW-3150.
1.
Install CCTV cameras at each required position.
2.
Connect BNC cable between CCTV camera’s V-out and FW-3150’s V-in.
3.
Connect a LAN cable at FW-3150 in your local network.
4.
Connect the power cable at FW-3150.
After that, you need to follow the steps below.
z
First, Network Configuration by FW-installer.
z
Second, Camera Configuration by FW-installer or admin-menu.
z
Third, Service Configuration by FW-installer or admin-menu.
)
For IP setup, refer to “Chapter 2.Network Configuration” on User’s Manual Part2.
