Arduino MKR board installation
To install your own Arduino MKR board in Iono MKR, or replace a pre-installed board, no
tools are required. The Arduino MKR board top side pin headers (female) connect to the
pin headers (male) of the top Iono MKR board. The Arduino MKR board is installed upside
down, with the micro USB programming near the relay outputs terminal block.
Static electricity can damage the components in your system. To protect your system's
components from static damage during the installation process, touch any of the unpainted
metal surfaces on your computer's frame or wear an ESD wrist strap before handling
internal components. Either method will safely discharge static electricity that's naturally
present in your body.
When handling the Arduino MKR, be sure to hold it along the side edges using your thumb
and index finger. Avoid touching the components and pin connectors as damage can
occur.
NOTICE
16
Iono MKR User Guide
