Disposal
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate
collection systems). This marking on the product, accessories or literature
indicates that the product should not be disposed of with other household
waste at the end of their working life. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, please
separate these items from other types of waste and recycle them responsibly
to promote the sustainable reuse of material resources. Household users
should contact either the retailer where they purchased this product, or their local
government office, for details of where and how they can take these items for
environmentally safe recycling. This product and its electronic accessories should not be
mixed with other commercial wastes for disposal.
Iono RP D16 optionally contains a small non rechargeable manganese dioxide lithium coin
battery. The battery is not accessible from the outside. You should first remove the case
body to gain access to the Iono RP D16 circuit boards. Always remove the battery before
disposing of this product.
Installation and use restrictions
Standards and regulations
The design and the setting up of electrical systems must be performed according to the
relevant standards, guidelines, specifications and regulations of the relevant country. The
installation, configuration and programming of the devices must be carried out by trained
personnel.
The installation and wiring of connected devices must be performed according to the
recommendations of the manufacturers (reported on the specific data sheet of the product)
and according to the applicable standards.
All the relevant safety regulations, e.g. accident prevention regulations, law on technical
work equipment, must also be observed.
Safety instructions
Carefully read the safety information section at the beginning of this document.
Set-up
For the first installation of the device proceed according to the following procedure:
✓
make sure all power supplies are disconnected
✓
install and wire the device according to the schematic diagrams on the specific data
sheet of the product
✓
after completing the previous steps, switch on the 230 Vac supplying the power supply
and the other related circuits.
29
Iono RP D16 User Guide
