Conformity Information
EU
This device complies with the following applicable European Community harmonised
standards:
✓
2014/30/EU - Electromagnetic Compatibility Directive (EMC)
✓
2014/35/EU - Low Voltage Directive (LVD)
✓
2011/65/EU and 2015/863/EU - Restriction of the use of certain hazardous substances
in electrical and electronic equipment (RoHS)
The following harmonised standards have been used to demonstrate conformity to these
directives:
✓
EN60664-1:2007 - Insulation coordination for equipment within low-voltage systems
✓
EN61000-6-2:2019 - EMC Immunity standard for industrial environments
✓
EN 61000-6-3:2007/A1:2011/AC:2012 - EMC Emission standard for residential,
commercial and light-industrial environments
The declaration of conformity is available at: https://www.sferalabs.cc
USA
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this equipment to maintain compliance with FCC
regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
35
Iono Pi User Guide
