S
M
M
InPut
InPut
4.4 P
Programming m
menu
(according to options)
4.4.1 Programming of the input
dISPL.
OUt.MA OUt.U
JbuS
tor
rELAY
SECU
Pr.diS
SAvE
SAvE
Access to the programming of the network type, CT
and VT ratios ...
Access to the programming of the 3 displays, the
voltage and current cut-off, filtering
Access to the analog output programming
(option analog output)
Access to the communication parameters
(option digital output)
Access to the programming of the LOGIC inputs
(option LOGIC inputs)
Access to the relay programming (2 or 4 relays)
(option relay outputs)
Access to the programming of the relay outputs in case
of error self-diagnosis
Access to the display programming :
Leds, Bargraph, Display brightness
Access to the programming exit menu with or
without recording the configuration
choice of the current caliber
if auto caliber
caliber 1A
caliber 5A
enter CT primary value (decimal point + unit)
or full display scale for the current input
Note :
⇒
Press key to revert to menu
⇒
In mode programming, the instrument will automatically revert to
measure with the former configuration if no key is pressed during 1min.
Move through menus / choice
M
M
diSPL.
Note :
Press to revert to
menu
or
«
Pri.tc
«
8.888
1A
5A
enter CT secondary value
or current input full scale
«
SEC.tc
«
005.0
«
p6
p8
p8
p9
p9
p10
p8
p7
p7
«
CAL1
InPut
choice of the voltage caliber
caliber 500V
150
500
«
«
«
choice du calibre
manual
automatic
MAnu
Auto
«
«
CAL
«
«
CALU
Sin
dEFOr.
«
«
SiGnA.
«
enter VT primary value (decimal point + unit)
or full display scale for the voltage input
«
Pri.tP
«
8.888
enter VT secondary value
or voltage input full scale
«
SEC.tP
«
500.0
Downwards move /
decrease
Validation / Vertical move
Menu exit /access
Upwards move /
increase
M
M
caliber 150V
diSPL.
sinusoidal
signal
deformed signal
(eg. : phase angle)
