North American T-28 Trojan
24
The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
HINGING THE ELEVATOR.
Glue the elevator hinges in place using the
same techniques used to hing the ailerons.
INSTALL ELEVATOR CONTROL HORN.
Fiberglass control horn
Epoxy.
Elevator fiberglass control horn.
Epoxy.
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
Draw center line
2) Place the stabilizer on the stabilizer
mounting platform at the rear of the fu-
selage.
3) With the horizontal stabilizer centered
and held firmly in place, temporarily in-
stall the vertical stabilizer and use a pen
to draw lines onto the stabilizer where it
and the fuselage sides meet. Do this on
both the right and left sides and top and
bottom of the stabilizer.
Summary of Contents for NORTH AMERICAN T-28 TROJAN
