14
The G-1 Beam (POI) is controllable using a DMX control device, and it can be connected using either a DMX cable, or via the fixture’s
built-in CRMX wireless receiver system.
When using a cabled DMX system, connect the DMX-In cable (with male 5-pin XLR plug) to the input connector and DMX-Out
cable (with female 5-pin XLR plug) to the output, both located on the rear of the fixture’s base. Terminate the DMX out cable of the
last fixture in the data link with a 120 ohm DMX termination. For outdoor installations, use only IP-rated XLR connectors suitable
for outdoor use.
In standard fixtures, if using a wireless DMX system, remember to connect the DMX output to the DMX in connector, and ensure they
are properly inserted in order to maintain the fixtures’ IP rating.
NOTE: SGM fixtures provide a passive DMX Thru signal as DMX Out, instead of an active output signal.
For POI versions, please refer to page 25-26 to see how to connect DMX and AC power.
Connecting a wireless transmitter (POI n/a)
The standard G-1 Beam is designed to look for wireless transmitters in ‘connect’ state, when this option is not yet enabled.
To connect the standard G-1 Beam to a wireless transmitter:
•
Log off the currently paired wireless transmitter - see below “Disconnecting a wireless transmitter” .
• Press the connect button on the wireless transmitter.
•
Confirm that the fixture has been paired with the wireless transmitter.
Disconnecting a wireless transmitter (POI n/a)
To disconnect the fixture from the currently paired wireless transmitter go to:
•
SETTINGS → WIRELESS DMX → LOG OFF, in the menu
Signal priority (POI n/a)
The G-1 Beam can be paired to an active wireless transmitter simultaneously as being connected to cabled DMX.
The fixture will prioritize cabled DMX over wireless DMX. The active input type is displayed under the wireless signal strength
indicator. See “Active input type” on page 13, to confirm the active input type of the fixture.
Connecting to a DMX control device
Summary of Contents for G-1 BEAM
Page 1: ...USER MANUAL MOVING HEADS SERIES G 1 BEAM G 1 BEAM POI ...
Page 30: ...30 User Notes ...
Page 31: ...31 User Notes ...
