SGM G-1 BEAM, User Manual

23

Supported RDM functions

The G-1 Beam (POI) features support for various RDM functions. 
RDM (Remote Device Management) is a protocol enhancement to USITT DMX512 that allows bi-directional communication between 

the fixtures and the controller over a standard DMX line. This protocol will allow configuration, status monitoring, and management.
An RDM controller is needed to get control over the supported parameters. See the tables below for G-1 Beam (POI) supported RDM 

functions.

RDM functions

RDM

Name

Sensor Type

Mainboard Temp.

Temperature

Head Board Temp.

Temperature

Light Source Temperature

Pan Angle

Angle

Tilt Angle

Angle

Wireless Signal Strength 

Other

Wireless Paired

Other

Battery Voltage

Voltage

Name

Sensor Type

Mains Voltage

Voltage

Humidity

Humidity

Compass

Angle

LSM303D X coordinate

Other

LSM303D Y coordinate

Other

Pitch

Other

Roll

Other

Light PWM

Other

PID

Actions allowed Name

0x0082

GET / SET

Device label

0x0081

GET

Manufacturer Label

0x00E0

GET

DMX Personality 

0x00E1

GET

DMX Personality Description

0x0200

GET

Sensor Definition

0x0201

GET / SET

Sensor Value

0x0080

GET

Device Model Description

0x1001

SET

Reset Device

0x0051

Parameter description

PID

Actions allowed Name

0x0090

SET

Factory Defaults

0x0501

GET / SET

Display Level, 0=OFF, 1 and 
above=ON ( POI n.a.)

0x0500 

GET / SET

Display Invert (POI n.a.)

0x0400

GET / SET

Device Hours

0x0401

GET / SET

Lamp Hours

0x8626

SET

CRMX Log Off

0x8630

SET

North Calibration

Please note: 

The RDM controller communicates with the fixtures to show only the available options for each RDM function. The table is subject to change without notice.

Sensors

RDM enables various sensor readouts for remote device monitoring. See the table below for sensors and sensor types.

Please note: 

The RDM controller communicates with the fixtures to show only the available sensors for this fixture. 

The table is subject to change without notice.