SGM G-1 BEAM, User Manual

28

SGM Uploader cable 

The SGM USB to DMX cable is an accessory used mainly to update the fixture with the 

latest SGM firmware. See below how to update the fixture with the latest firmware. 
The  SGM  Uploader  cable  is  also  used  for  controlling  the  DMX  values  channel  by      

channel  through  the  Firmware  Uploader  Tool  software  (available  for  download  at                  

www.sgmlight.com).

Upgrading the firmware

The firmware installed in the fixture can be identified in different ways:

• 

When powering on the fixture, the display shows the current installed firmware version (only standard).

• 

Go to MENU → INFO → FIRMWARE VERSION (only standard).

•  Through RDM.

We recommend that the fixture’s firmware is always up-to-date.

 The latest firmware version is available for download under the         

respective product at www.sgmlight.com.
To update your G-1 Beam (POI) with the latest firmware, use an SGM USB 5-Pin-XLR uploader cable, and a Windows-based com

-

puter with the SGM Firmware Tool software installed (available for download at www.sgmlight.com).

Additionally, the Firmware Tool software offers a simple DMX controller featuring 512 DMX channels for test purposes.

SGM Vacuum Test kit

The Vacuum Test Kit is an accessory suitable for all SGM IP-rated fixtures, made for testing the IP 

validity after having reassembled the fixture.
In order to ensure the IP-rating of the G-1 Beam (POI), it’s highly recommended that the fixture is 

always vacuum tested after installing or swapping any part that might compromise the IP-rating.
SGM disclaims liability for any damage occasioned by the non-use, or inability to use, the vacuum 

test kit after reassembling the fixture. 

Cleaning

SGM  luminaires  with  IP65  or  IP66-rating  do  not  need  any  cleaning  procedures  inside  the          

fixture. However, cleaning the front lens may be needed to achieve the maximum light output 

afte exposure to dust, sand, or dirt. Exterior housing can also be cleaned to get a better look. To 

maintain adequate cooling, fans must be cleaned periodically.
Whenever necessary, clean the G-1 Beam using a soft cloth dampened with a solution of water 

and a mild detergent. Do not use  products that contain solvents, abrasives, or caustic agents 

for cleaning, as they can cause damage to hardware, cables, and connectors.  
The level of cleaning required will vary greatly depending on the operating environment and 

installation. When the G-1 Beam is used hanging outdoor for prolonged periods of time,it is 

essential to keep the drain around the DMX connectors under the base clean and free from 

accumulated dust, dirt, foliage etc. Therefore, it is recommended  to do frequent check-ups the 

first few weeks of operation to see how often cleaning is necessary.

Maintenance

Figure 30: SGM Firmware tool

Figure 29: SGM Uploader cable

Drain

Figure 31: SGM Vacuum Test Kit

Figure 32: G-1 Beam cleaning