17
GiottoSpot 400 rel.1.01
Control Microcomputer
GB
Menu
Options
Description
Addr=xxx Range 001-495
Fixture addressing
NORM
Normal PAN control of left to right PAN movement.
Pmove
REV
Inverted PAN movement control (from right to left).
PP_min
Range 000-540
Sets PAN movement start position.
Default configuration = 000 degrees
PP_max
Range 000-540
Sets PAN movement stop position.
Default configuration = 000 degrees
NORM
Normal control of TILT from up to down.
Tmove
REV
Inverted TILT movement control (from down to up).
TP_min
Range 000-270
Sets TILT movement start position.
Default configuration = 000 degrees
TP_max
Range 000-270
Sets TILT movement stop position.
Default configuration = 000 degrees
ON
Data regarding Pan controls Tilt and vice versa.
Swap
OFF
Normal control of Pan and Tilt movement.
Lmp_H
-
Read-only Menu. Stores lamp elapsed time. Can be reset.
Lmp_st
-
Read-only Menu. Stores the number of lamp strike. Can be reset.
SCN_h
-
Read-only Menu. Stores fixture operating time.
DMX
DMX signal selected
SIGN
RS-232
RS-232 signal selected
SMD
16 bit
8 bit
Enables selection of movement resolution.
Default configuration = 16 bit
EN
Remote lamp ignition enabled.
LMP_ctr
DS
Remote lamp ignition disabled.
EN
Remote reset enabled.
RST_ctr
DS
Remote reset disabled.
Speed
100% - 92%
84% - 76%
Allows to slow maximum Pan and Tilt speed.
Default configuration = 100%
Fast
Optimises speed performance.
Accel
Slow
Optimises smooth movement
Bright
100-53-40-27-
20-13-6-0 (%)
Allows adjustment of display brightness.
Default configuration =40%
DsplFlip -
Inverts display reading position. Used according to the position in which the fixture is
installed.
Range 8-600sec
It’s possible to set the number of second for which the fixture’s last operating status must
be held when there is no DMX signal. (default =20sec.)
DMXdly
UNL
Always maintains the fixture’s last operating status no matter for how long there is no
DMX signal.
CSHUTT=DS
Disables shutter closure in the event of loss of position
CSHUTT
CSHUTT=EN
Enables shutter closure in the event of loss of position
FACT=SET
Enables to set default parameters
FACT
FACT=OFF
FACT Value during normal operation
PREV=SET
Enables to restore the values of the parameters set immediately before FACT=SET
procedure
PREV
PREV=OFF
PREV value during normal operation
COL=1200
Enables to set the offset for calibrating the starting position of the colour wheel
GOB=2000
Enables to set the offset for calibrating the starting position of the gobo wheel
RGOB=1100
Enables to set the offset for calibrating the starting position of the rotating gobos
SETTING
EFF=2000
Enables to set the offset for calibrating the starting position of the effects wheel
-
-
TEST
TEST=RESET
Fixture RESET.
Reserved -
-
ADDR=100 -
Under normal operating conditions, the display shows this message (100 is the DMX 512
channel on which the first channel set)
