GB
SGM Technology for Lighting
Synthesis Wash 700
User’s Manual 1.00
- 25 -
Setting Pan movement starting angle
Synthesis has a Pan movement range of 530°. If the entire excursion doesn't
have to be used, two parameters allow to set the starting angle (MIN) and
ending angle(MAX), which 4°. To limit pan movement, proceed as follows:
1.
Connect Synthesis to the power supply, wait till it has completed
reset operations.
2.
Use the UP/DOWN keys to find the “Pan Pos Min” menu if the starting
angle has to be modified. If the ending angle has to be modified, find
the “Pan Position Max” menu. It is not necessary to use the max
excursion, two parameters allow to limit the starting angle (Pan
Position Min) and the ending angle (Pan Position Max).
3.
Press Enter to confirm.The message on the display will start to flash.
4.
Use the UP/DOWN keys to select the new starting (or ending) angle.
5.
Press Enter to confirm.
Direction of Tilt movement
This function allows to decide the direction in which Synthesis moving heads
tilts, indispensable when several fixtures indispensabile s are installed in
order that fixtures installed opposite each other move in the same direction
when they receive a command.
To modify Pan movement, proceed as follows:
1.
Connect Synthesis to the power supply, wait till it has completed
reset operations.
2.
Use the UP/DOWN keys to find the “Tilt Move” menu
3.
Press ENTER to confirm. The message on the display will start to
flash.
4.
Use the UP/DOWN keys to select which of the two available options is
required.
5.
Press Enter to confirm.
Limiting Tilt movement
Synthesis has a a Tilt movement range of 250°. If the entire excursion
doesn’t have to be used, two parameters allow to limit the starting angle
(Tilt Pos Min) and the ending angle (Tilt Pos Max). The only limiti s the
minimum difference between starting (MIN) and ending(MAX), which is 4°.
To limit the tilt movement procede as follows:
1.
Connect Synthesis to the power supply, wait till it has completed
reset operations.
2.
Use the UP/DOWN keys to find the “Tilt Pos Min” menu if the starting
angle has to be modified. If the ending angle has to be modified, find
the “Tilt Pos Max” menu. It is not necessary to use the max
excursion, two parameters allow to limit the starting angle (Tilt Pos
Min) and the ending angle (Tilt Pos Max).
3.
Press ENTER to confirm. The message on the display will start to
flash.
4.
Use the UP/DOWN keys to select the new starting (or ending) angle
5.
Press Enter to confirm.
PAN POS MAX=004
TILT MOVE=NORM
TILT POS MAX=004
TILT POS MIN=000
www.audiovias.com
Summary of Contents for Synthesis Wash 700
Page 47: ...www audiovias com...
