PAGE 5
PAGE 4
SAFETY MECHANISM
OPERATING A CONTACT TRIP SAFETY TOOL
The operator requires finger to be off the trigger and the work contact ele-
ment (WCE) of the tool to be placed on the work-piece.
The work contact element (WCE) is then depressed against the work-piece
and the trigger is pulled to drive a fastener.
The trigger is released after each fastener is driven.
Move the tool to next location and repeat the above procedure.
CHECKING A CONTACT TRIP SAFETY TOOL
Disconnect the air supply from the tool.
Empty the magazine.
Make sure the trigger and the safety move up and down without sticking.
Connect the air supply to the tool.
Depress the safety tip against the work-piece without pulling the trigger.
The tool must not cycle. Never use the tool if a cycle occurs.
Hold the tool clear of the work-piece. The WCE should return to its original
down position. Pull the trigger. The tool must not cycle. Never use the tool
if a cycle occurs.
WARNING
CHECK AND REPLACE ANY DAMAGED OR WORN COMPONENTS. SAFETY WARN-
ING LABELS ON THE TOOL MUST ALSO BE REPLACED IF THEY ARE NOT LEGIBLE.
LOADING THE TOOL
Open the magazine.
Check and adjust - the nail support can be set to four
positions. Pull the nail support and twist to the correct
setting.
Nail loading - Insert the coil and pull the nails to the feed
pawl. The nail head should be put into the nose slot.
Close the magazine and check the door is latched.
CORRECT CONNECTION OF THE TOOL
WWW.SGS-ENGINEERING.COM
