PAGE 13
PAGE 12
DRILL OPERATING INSTRUCTIONS
1. Lubricate the tool before operating. See “CARE AND MAINTE-
NANCE” section for oiling instructions.
2. Use the chuck key to open the chuck by screwing the key counter-
clockwise. (See Figure 1)
3. Insert a drill or a drilling accessory (not provided) into the chuck and
then tighten the chuck by turning the key clockwise. Make sure that
the drill/drilling accessory is installed securely and tightened before
operating the tool. (See Figure 2)
4. Remove the air cap from the tool air inlet and mount the male plug.
Connect the air supply hose to the tool. Set the air pressure at 90 PSI.
(See Figure 3)
5. Push F/R valve (Part #8) upwards (to “F” position) and press on the
trigger to operate the tool. (See Figure 4 & Figure 5)
6. Push F/R valve downwards (to “R” position) and press on the trigger
whenever you are releasing the drill out of the work piece. (See Figure
4 & Figure 5)
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
DRILL OPERATING INSTRUCTIONS
WWW.SGS-ENGINEERING.COM
