SC901P
7
6
SC901P
1 . S A F E T Y A D V I C E
GENERAL FUEL SAFETY
ALL FUELS ARE FLAMMABLE
Fire hazard - keep fuel away from all
sources of ignition, such as heaters,
lamps, sparks from grinding and weld-
ing.
DO NOT
carry out hot work on tanks
that contain fuel.
ALWAYS
keep the work area tidy.
ALWAYS
clean up spills promptly.
ALWAYS
dispose of waste fuels
correctly.
FUELING / DE-FUELING
ALWAYS
fuel and de-fuel in a well
ventilated area outside of buildings.
ALWAYS
wear correct, suitable and fit
for purpose PPE. Suggested items are,
but not limited to safety gloves and
overalls.
When fueling/de-fueling,
ALWAYS
dispose of waste fuels correctly.
When de-fueling
ALWAYS
use a proper
fuel retriever.
ALWAYS
carry fuel in a correct and
clearly marked container.
CAUTION
If you think you have or someone
around you has been affected by
carbon monoxide poisoning:
1. Get them fresh air immediately,
by leaving the affected area or by
opening doors and windows. If safe
and practical to do so, make sure
that the machine is turned off.
DO
NOT
enter a room you suspect of
having carbon monoxide present
– instead call the emergency
services.
2. Contact a Doctor immediately
or go to Hospital – let them know
that you suspect carbon monoxide
poisoning.
DANGER
Ensure that the compressor is in good order
and condition before use. If in any doubt do
not use the compressor and contact your
service agent.
Before moving or maintaining the
compressor, ensure that the air tank
pressure has been vented.
Only use recommended attachments and
parts. Unapproved items may be dangerous
and will invalidate the warranty.
Read the instructions for any accesso-
ry used with the compressor. Ensure
that the safe working pressure of any air
appliance used exceeds the output
pressure of the compressor. If
using a spray gun, check that the area
selected for spraying is provided with
an air change system or adequate
ventilation.
Make sure that the air supply valve is turned
off before disconnecting the air supply hose.
Use the compressor in a well-ventilat-
ed area and ensure it is placed on a firm
surface.
Remember that the air
compressor’s engine produces harmful ex-
haust fumes.
Keep tools and other items away from the
compressor when it is used and keep the
work area clean.
Make sure that the air hoses are not
tangled, twisted or pinched.
DO NOT
disassemble the compressor
for any reason if you are not qualified
to do so. The unit must be checked by
qualified persons only.
DO NOT
operate the compressor within
the vicinity of flammable liquids, gases or
solids.
DO NOT
attempt to move the
compressor by pulling the air hose.
DO NOT
use the compressor for a task for
which it was not designed.
DO NOT
deface the certification plate at-
tached to the compressor tank.
DO NOT
operate the compressor
without an air filter.
DO NOT
use the compressor indoors, the
exhaust fumes are poisonous.
DO NOT
allow anyone to operate the com-
pressor unless they have received full in-
struction.
DO NOT
check the ignition system by re-
moving the spark plug or spark plug lead.
Use a specific tester or contact a service
agent.
Make sure that the engine fuel is stored
in an appropriate container. For long
term storage ensure that the fuel tank
is drained and that the compressor is
adequately protected.
CAUTION
DO NOT
direct the output jet of air
towards people or animals.
WARNING
DO NOT
touch the compressor cyl-
inder, cylinder head or pipe from the
head to the tank as these may be hot
and will remain so for some time after
shutdown.
DANGER
DO NOT
smoke or have any naked
flames nearby whilst refuelling.
DANGER
DO NOT
operate the compressor if
there is a fuel leak. Move the unit to a
safe area where there is no risk of
ignition until the leak has been
rectified and the machine is dry.
NOTE
YOU MUST
drain condensation from
the tank daily and inspect inside walls
for corrosion every 12 months.
DO NOT
remove the fuel cap, or try to re-
fuel whilst the engine is running. Stop the
engine and allow it to cool for two minutes
before attempting to refuel
DO NOT
tamper with the safety valve and
DO NOT
modify or alter the tank in any way.
DO NOT
subject the tank to impact,
vibration or heat.
1 . S A F E T Y A D V I C E