15
Operating
program 2
21)
22)
23)
24)
Finish setting program
press program button for 1 sec to start.
Operating
program 1
After setting
press SET for 1 sec
RPT is repeat mode of section,
available setting 1~999.
You don't need to use repeat function
please set as "1"
After setting
press SET for 1 sec
REN is setting setting last segment No of repeat
mode. But you don't need to use repeat
function. So please set as "0".
After setting
press SET for 3 sec
RST is setting setting last segment No of
repeat mode. But you don't need repeat
function. So please set as "0".
※ Initial value "1" (Do not change).
※ Initial value "0" (Do not change).
※ Initial value "0" (Do not change).
Press SET for 3 sec after setting.
It goes to stand by mode.
Summary of Contents for SH-FU-1.5MGV
Page 20: ......