ShadeFX Installation Guide
16
REV
. 0
3/2
021
Mounting the Track Supporting Beam to the Posts
iii.
With two ladders set up in front of each arm, two laborers are to simultaneously raise the track
supporting beam to align the protruding threads with the slot in the arms. Slide the protruding thread
into the arm slots such that the
existing threads (with nuts) protruding from the plates are
inserted first.
Refer to the image below for insertion direction.
iv.
Set desired track angle (flat orientation shown below). This orientation can be changed at any time
(see ‘Post Assembly’). Insert 3/8”-16 x 1-1/2” hex bolt with 3/8” washer into the plate hole when
the appropriate hole in the post is aligned. Repeat on other side of the track supporting beam.
20º from Horizontal
(Tilted Backwards)
Horizontal
20º from Horizontal
(Tilted Backwards)
