Current State Storing
It is possible to save the current modes, response type, levels,
and ACV assignment by pressing and holding the ACV button
[G]
for 2 seconds. All LEDs will blink to confirm the storage.
Patch Ideas
1. Percussive envelopes: set 3 channels of decay with
exponential response, enable accents, and start designing drum
sounds!
2. Cascaded clocked LFOs: configure the 3 channels in clocked
loop mode, insert a clock into channel 1 input, and create
modulation signals based on subdivisions (channel 1, 2 & 3) of an
incoming clock signal.
3. Delayed envelopes: trigger channel 1, give it some attack
time using the symmetry potentiometer
[A]
. Without anything
inserted into channel 2 input, envelope 2 will be triggered when
channel 1 attack phase ends. In other terms channel 2 will be
delayed by the attack time of channel 1.
4. Triggered ASR with control upon sustain time: in the same
order of ideas, trigger channel 1 in trigger mode with symmetry
fully counterclockwise, and without any cable inserted into its
gate input, put channel 2 in gate mode. While channel 1 is
decaying, channel 2’s signal will rise and hold its sustain phase.
When channel 1 decay is over, channel 2 will finally go into its
decay phase.
