Place the jig onto white rubber feet, squeeze barrel and press until it clicks
into place. Next press the green ‘tick’ to confirm that the jig is in place
followed by the big green ‘go’ button to start tracing.
4
After a short while the tracer stops tracing, beeps and requests the
next jig. This is the black ‘frame’ jig that is unique to your tracer and
numbered as such, eg. if it says on the screen ‘M12485’ your jig will have
this number printed on it. Insert the jig into the jaws and press the green
‘tick’ to confirm that you’ve done it followed by the big green ‘go’ button
to start tracing.
5
After the second jig has finished tracing the machine will take a moment
to calculate the data. This normally takes a few minutes, after which
time the machine beeps to tell you it’s done. You then have to press the
green ‘tick’ to confirm and the machine is now ready to trace again.
6
Summary of Contents for Star
Page 1: ...Quick Start User Guide ...
