DAILY CALIBRATION CHECK
Press the frame button to tell the machine you intend to do a calibration
check. The frame symbol will be highlighted and the machine will ask
for the frame jig, insert this now.
1
Press the green ‘tick’ button followed by the big green ‘go’ button. This
will set the trace going. When finished the machine will either display
‘Check OK’ or if the check fails ‘Check KO’.
2
If the check is ok then you can begin tracing, else a full calibration will
be required.
3
It may not always be necessary to perform a full calibration. Usually a simple
check will suffice and if it passes the calibration can optionally be skipped. Note
that it is still a good idea to calibrate periodically regardless of the check.
Summary of Contents for Star
Page 1: ...Quick Start User Guide ...