Handlebar Switches
1.
Dimmer Switch
When light switch is in the “ON” position
Push in to turn on the high beam.
Push out to turn on the low beam
2.
Turning Light Switch
To use the turning light while making a turn or changing traffic lane, press the directional switch,
press toward the left arrow to turn on the left turn signal, press toward the right arrow to turn on
the right turn signal. The turn signal doesn’t go off automatically, once you completed your turn,
push the switch to the middle position to turn off the signal lights.
3.
Horn button
Press the horn button to sound the horn.
4.
Light Switch
Push up to turn all on the headlights.
Push toward the bottom to turn off all lights.
5.
Starter Switch
Push this button to use the electric start function. Brake must be engaged and side stand up to
complete circuit.
6.
Engine turn “ON/OFF” Switch
Push toward the top to shut the engine off.
Push toward the bottom to set the engine to ready to start position. You will either use the
electric start button or use the kick start to start the engine.
NOTE: When you use the electric start button to start the engine, always release the starter switch
immediately after the engine has started. Do not push the starter switch again once the engine is
running. NEVER exceed 4 seconds when using starter switch each time or it will drain down
the scooter battery.
