Engine Oil
1.
Oil Level Measurement
a.
Place the scooter on the center stand.
Warm up the engine for several minutes.
b.
Stop the engine and wait a few minutes
until the oil levels before removing the
dipstick.
c.
The oil level should be between the
minimum and maximum mark on the
dipstick. If the level is low, add oil to
raise to the specified level.
NOTE: Be sure your scooter is positioned
straight up when checking the oil level. A
slight tilt toward the side can result in false
readings.
2.
Engine oil replacement. Replace engine oil after the initial 300 Km (180 Miles). Thereafter,
replace engine oil every 1,000 km (600 Miles). Check the oil level every day before using.
Add oil to specified level if necessary.
3.
Start the engine and warm up for a few minutes. While warming up, check for oil leakage. If
oil leakage is found, stop the engine immediately and check for the cause. Follow the steps
below to change the engine oil:
a)
Warm up the engine for a few minutes
b)
Stop the engine. Place an oil pan under the
engine and remove the dipstick.
c)
Remove the drain plug and drain the oil
d)
Clean the oil filter with solvent
e)
Reinstall the oil filter and drain plug
f)
Fill the engine with oil and install the dipstick.
NOTE: if your scooter is often ridden on bumpy
roads, in cold weather, or for short distances, engine
oil should be replaced sooner than prescribed by this
manual. Consult your local dealer for
recommendations.
