Shanling DR2.1, Manual

DR2.1

4

MEDIA STREAMER

Operation Instructions

Electrical Connections

Turn on/off

Play/Pause

Previous track/next track (effective for local play)

MODE

Working Mode

1. Audio output connection: The unit provides two signal output interfaces, i.e.

Digital coaxial interface and analog audio interface, for the connections to
decoder and amplifier.

2. Input connection: The unit provides two signal source input interfaces, i.e. WIFI

interface and Micro SD card. Connect the accompanying WIFI antenna to the
WIFI interface on the rear panel.

1. First connect the unit power cord and signal line, and the power indicator turns

green. The unit directly enters normal working status.

2. To turn off the unit in normal working status, press [

] key, and the power

indicator turns red. At this time, the unit is in standby status. If the unit is not to
be used for some time, it should be unplugged to disconnect it from AC power.

In stop status, press [      ] key to play the current track. Press again to pause.

Press [     ] key to play the previous track. Press [     ] key to play the next track.

Short press [MODE] key: The playing status switches between network mode and
local mode.

Long press [MODE] key: Switch between peer to peer and network to peer in
network mode.

"

"

"

"

The unit provides two working modes, i.e. WIFI and LOCAL, indicated by two LED
indicators.

1. Direct mode (peer to peer)

The unit will automatically generate WIFI (hotspot) when being electrified for the
first time. Open the WIFI of your mobile phone or computer, connect to this
network (default SSID:Shanling AP-xxxxxx, PSW:00000000). Run the player
software, the local music and the music in SD card or the music shared to
other devices in this network will be shared to this unit. In this mode, WIFI
indicator is off.