ABM-D 135
12-12-2018
-16-
Ruben Rapati
LOWER HEATING PROFILE POSITIONING
Only the front heating profile can be changed in position.
1
Clear the working surface.
2
Loosen the fixing wheels left and right (
page 9
)
3
Turn the wheel (
K
) till the orange indicator shows the correct distance between
the 2 heating wires of the profiles in millimeters.
4
Tighten the fixing wheels again. (
page 9
)
PARALLEL BACKSTOP
1.
Loosen the nuts on the stop one half turn.
2.
Slide the stop into the desired position.
3.
Tighten the nuts.
Always ensure that the stop is placed in such a way that heating elements or
pressure bars cannot hit the stop as they are lowered.
ANGULAR STOP
1.
Loosen the nut on the protractor.
2.
Put the nut into the desired position.
3.
Tighten the nut.
4.
Make sure both left and right side are placed in the same position.
5.
Run the machine without a piece of plastic, to check if the set angle is accurate
enoug
K
