49
sharkclean.eu
48
sharkclean.eu
MAINTAINING YOUR VACUUM
CLEANING THE FILTERS
Regularly rinse and reinstall the filters to maintain your vacuum’s suction power.
To clean filters, rinse them with water only. Allow all filters to air-dry completely before reinstalling to
prevent liquid from being drawn into electric parts.
Clean the pre-motor filters at least once a month and post-motor filter at least once a year. Tap off loose
dirt between washes when needed. More frequent cleaning may sometimes be necessary with heavy use.
IMPORTANT: DO NOT
use soap when cleaning the filters. Use water only. The vacuum will not have suction if the post-motor
filter is not installed. Ensure that all filters are installed before using.
PRE-MOTOR FILTER
Press the dust cup release button and remove the
dust cup. Pull the foam and felt filters out of the
back of the dust cup.
Remove the dust cup. Pull the post-motor filter out
of the handheld vacuum.
Pre-Motor Foam and Felt Filter Kit
Post-Motor Filter
ENGLISH
FLOOR NOZZLE
MAINTAINING YOUR VACUUM
FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor
surface, a low-pile carpet, or a small area rug. If some fibers remain wrapped around the brushroll after
continued use, carefully remove them. If you run over a hard or sharp object or notice a noise change while
vacuuming, check for blockages by following the steps under ‘Checking for Blockages in the Floor Nozzle’
on the bottom right of this page.
POST-MOTOR FILTER
