FAMILIARÍCESE CON LA PLANCHA
TROUBLESHOOTING
PROBLEM
POSSIBLE REASONS & SOLUTIONS
Iron does not heat
Some odor or small
particles come out of
steam vents of new
iron
Iron does not steam
Water droplets coming
from steam vents
• Iron should be plugged into a 120V AC electrical
outlet only.
Make sure that the plug is securely in the socket.
• Temperature setting too low.
Turn to higher setting.
• This is normal.
Follow instructions for first use and allow iron to steam
through 2-3 fillings & press the steam burst button
occasionally to eliminate small white particles.
• Water tank may be empty or water level is very low.
Add water.
• Make sure that the fabric/temperature setting and
the variable steam control are correctly set. For
maximum steam, (setting ‘Max’ on steam control),
temperature setting should be set on ‘•••’.
• Variable steam control dial is set on “0”.
Always allow the iron to reach the selected
temperature with the variable steam control setting
at ‘0’. Make sure the temperature setting is set in
the correct steam area, e.g. ‘•’, and the steam control is
not on ‘0’. For more steam, turn temperature dial to
higher setting, e.g. ‘•••’, and the steam control to ‘Max’.
• If temperature setting and steam control setting are
correct and there is no steam, gently tap the
soleplate on the ironing board a few times. Move
the variable steam control from ‘0’ to ‘Max’ a few
times.
• Iron may not be hot enough. Set thermostat to the
‘Max’ position. Always allow iron sufficient time to
heat up before activating the variable steam control.
• Overuse of steam burst. Allow more time between
each burst.
• Iron may have been overfilled. Turn iron off,empty
water and follow instructions for filling.
• Steam performance may be low if iron requires
seasoning. To season, use regular tap water for 1or 2
tanks until steam performance improves.
El olor es inocuo y no debe volverse a
producir después del calentamiento
inicial.
También, antes de planchar por primera
vez con vapor, permita que la plancha se
caliente sosteniéndola en posición
horizontal y apriete varias veces el botón
para ráfagas de vapor. La plancha podría
arrojar algunas partículas pequeños por
los orificios del vapor. Esto es normal, y
cesará después de presionar el botón de
ráfagas de vapor varias veces.
12
11
13
14
PANEL de Diodos Indicadores
Antes de usar la Plancha Electrónica, retire
los rótulos, etiquetas autoadhesivas, etc.
que vienen adheridas al cuerpo o a la suela
de la plancha.
Cuando se encienda por primera vez, la
plancha emitir un olor durante unos 10
minutos. Esto se debe al calentamiento
inicial de los materiales en los que se ha
fabricado la plancha.
8.
Visor de Nivel de Agua
9.
Suela de Acero de la Plancha
10. Asa de la Plancha
11. Luz de Apagado Automático
12. Luz Indicadora de Corriente
13. Graduaciones para Telas y Vapor
14. Indicadores de Temperatura
15. Jarra Llenadora de Agua
1. Botón de Control Electrónico de Temp
2. Panel de Diodos Indicadores
3. Botón Atomizador de Agua
4. Botón Aplicador de Chorro Corto o
Largo de Vapor
5. Dial Regulador de Vapor
6. Tapa de la Toma de Agua
7. Boquilla Atomizadora de Agua
13
10
