15
16
sharkclean .eu
0800 862 0453
MAINTAINING YOUR VACUUM - CONT�
1
Open the brushroll lid by sliding both release buttons away
from you, toward the back of the nozzle, then lifting off the
lid. Remove any string, hair, or debris that may be wrapped
around the brushroll by running scissors along the guide on
the brushroll.
2
Press down on both sides of the lid until it clicks into place.
WARNING:
To reduce
the risk of shock and
unintended operation,
turn off power and
unplug unit before
servicing.
WARNING:
When
cleaning brushroll, be
sure to not cut anything
other than hair, string,
fibres, or other debris.
TIP:
If nozzle headlights
are flashing, then the
brushroll garage is not
completely closed. Ensure
the garage is completely
closed by pressing down
firmly on both sides.
NOTE:
Heavy usage over
time may require minimal
upkeep to maintain your
vacuum’s appearance.
STEP 1
STEP 2
MAINTAINING THE BRUSHROLL
MAINTAINING THE SOFT ROLLER
1
Open the brushroll by sliding both release
buttons away from you, toward the back of
the nozzle, then lifting off the lid. Lift out the
Soft Roller by the tab on the right side. Clean
off any string, carpet fibres, or hair that may
be wrapped around the Soft Roller. Remove
debris from the roller housing.
2
Wash the Soft Roller as needed, using only
water. Air-dry completely for at least 24 hours
before returning it to the brushroll garage.
3
Reinsert the Soft Roller by sliding it into the
front of the nozzle until it clicks into place.
Close the brushroll garage by inserting the
tabs on the lid into the slots, then pressing
down on both sides of the lid until it clicks
into place.
CHECKING FOR BLOCKAGES:
HANDHELD, WAND, AND FLOOR NOZZLE
1
Remove the wand from the handheld
vacuum and check all intake openings on
the dust cup.
2
Remove the floor nozzle from the wand
and check the wand for blockages.
3
Tilt neck of floor nozzle back to straighten
the airway, then remove blockages.
