9
AU
02 8 8 01 76 6 6
NZ
0 8 0 0 112 6 60
8
AU
sharkclean .com . au
NZ
sharkclean .co. nz
NOTE:
All accessories are compatible with both the wand and the handle.
OPERATING THE VACUUM
CLEANING MODES
To engage brushrolls, step on floor
nozzle and tilt handle back.
Press power button to turn on vacuum.
Please note the brushrolls will not spin
until you have stepped on the floor nozzle
and tilted the handle back.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green:
The brushrolls are spinning and working as they should.
Solid Red:
There is a jam in the brushroll area. Turn off the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red:
The motorised floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
Press the
Wand Release
button to
detach the wand from the pod.
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug.
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brushrolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor.
With pod removed, press the
Wand Release
button to detach the
wand from the floor nozzle.
Press the
Handle Release
latch to
detach the handle from the wand.
Press the Powered
Lift-Away™
button
to detach the pod from the floor nozzle.
UPRIGHT
POWER SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—HANDLE
POWERED LIFT-AWAY™
ABOVE-FLOOR—WAND
SURFACE
LIFT-AWAY®
OPERATING THE VACUUM
SETTINGS
BRUSHROLL INDICATOR LIGHT
NOTE:
Try using Hard Floor mode for low pile area rugs.
