14
textile PaRtS
type
The textile and foam parts providing comfort to
the SHARK Nano and the SHARK Raw make it
easy for you to appreciate the performance of
your helmet to the best.
The parts in contact with the skin are made
in a fabric that is guaranteed to feel pleasant,
to absorb perspiration well and to resist wear
satisfactorily. We treat surfaces to limit the risk
of mould and bacteria.
Always in one concerns of hygiene, the outer
seal are treated against bacteria, what allows
avoiding their proliferation when we put the
helmet.
treatment
Warning: although they are selected for
their quality of resistance and satisfactory
wear, all the interior padding is subject to
normal wear depending on use and care
and maintenance, the length of use and also
the degree of acidity of your perspiration.
If you note any wear, we advise you to replace
the interior padding in order to keep your hel-
met perfectly clean and comfortable.
textile PaRtS
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not correspond
to the contours of your face.
maintenance
The interior textile parts are washable; it is
important to follow the instructions below
scrupulously to avoid damaging them.
The cheek pads and head section must be
hand washed in warm, soapy water (about
30°).
Do not use aggressive detergents but
either a product for delicate materials in
low dilution or household soap.
It is essential to dry textile and foam parts
completely before using them. They must be
dried at room temperature. Never iron textile
parts.
For parts with a leather appearance or textiles
attached to safety elements, use a slightly
damp sponge or cloth and household soap
and rinse with clean water.
Avoid allowing
too much water to come into contact with
polystyrene parts.
It is essential to ensure that all interior parts
are perfectly dry before using the helmet.
