10
TOLL FREE:
1-800-798-7398
General Tips:
• Change the Wood & Hard Floor Cleaning Pad frequently for best results.
• Always vacuum floors and carpets before cleaning or polishing.
• If you notice any uneven areas or streaking, DO NOT go over the same area with more polish if the floor
has begun to dry. Wait until the floor polish has totally dried for approximately a day before going over it
again with more polish.
• Never lift the
Sonic Duo
up at the end of a section of flooring that has been polished. Always slide the
unit off the floor and then remove the pad.
• When polishing, you should always leave each section looking wet, never dry, before going to the next
section.
• Try the Pretreater Carpet Stain & Odor Remover to eliminate your toughest stains. Just spray the solution
onto the stain until saturated, allow 5-10 minutes to set and then blot up the stain with a white cloth or
towel. Never scrub the stain, only blot.
Pad
Consumption
Hard Floor Cleaning Pad
Replace after 20 washes
Hard Floor Polishing Pad
Replace after 20 washes
Carpet/Rug Cleaning Pad
Replace after 20 washes
Carpet Scrub ‘n Stain
™
Removal Pad Replace after 20 washes
Cleaner
Consumption / Usage
Wood & Hard Floor Cleaner
Use 32 oz. diluted solution per 600 sq. ft.
Wood & Hard Floor Polish
Use 28 oz. solution per 425 sq. ft.
Activating Pretreater Carpet
Stain & Odor Remover
Fully saturate a spot or stain before blotting
Low Moisture - No Rinse -
Carpet Cleaner
Use 32 oz. diluted solution per 250 sq. ft.
Using Your Sonic Duo
™
- cont.
