Operating Instructions
WWW.SHARKS-SHOP.CZ
29
BEFORE USING
Installing a safety cover (protection hand)
Note:
You may have been to protect your hedge shears
installed. If not, as soon as possible before installing
remove the protective cover cutter bar in the direction of
the arrow. Insert protection on the machine body and
tighten the screws.
Use an extension cable
We recommend that the device was fitted with a residual current device with a maximum
tripping current of 30 mA. Only use extension cables suitable for outdoor use, the most highly
visible.
Specifications:
1. extension cable to 15 meters use a cross-section
of 1,5 mm².
2. extension cord longer than 15 meters and less than 40 meters, use the conductor
cross-section
of 2,5 mm².
Before the device works, check:
1. Make sure the hand guard is firmly attached to the body of the device.
2. Make sure that knives are broken or damaged.
3. Before the unit is plugged into a wall outlet and check for cable or extension cable is
damaged.
Note:
Do not use if the cord is damaged.
4. Make sure that the power supply corresponds to the unit. Hedge shears are designed for
values of 230V/50Hz
5. Check the operation of the device. Make sure that both switches are in good condition. The
appliance switches off after about one more second moves.
Intended use:
Use scissors for cutting branches only hedge for any other purpose.
Hedge shears are designed for cutting branches with a diameter not exceeding 16 mm.
Note: Make sure the place where you intend to work. Make sure that there is not already wires
or other metal objects.
OPERATION
Cable routing
Always route the cable outside the work area to get in touch with knives. Always plan a route
before the actual work with the device. Start working in a place that is nearest electrical outlet
and gradually diverge from it. In this way the cable does not get the device, thus preventing the
accidental cut. You increase your safety even more so that you have a cable laid across his
screws
