420 774 335 397 www.sharks-shop.cz Stránka 34
DESCRIPTION
1. base
2. center cover
3. handle with switch
4. safe cover
5. guide plate/fence
6. turnable table
7. laser
8. LED
BEFORE USE
CAUTION: To prevent accidental starting that could cause possible serious injury, before use, make
sure all the parts are in place, they are not damaged and are properly tightened.
If it is necessary to replace parts, always disconnect the unit from the mains. If a repair is necessary,
contact the service Sharks. Unauthorized intervention in the machine can cause damage to the saw or
injury.
CAUTION: If the device is not complete, do not use the equipment until the missing parts are replaced
with other original from the manufacturer.
After unpacking, check that the delivery is complete. In the absence of thanksgiving supplies, contact
your dealer. Do not discard the original packaging.
Note: If you do not complete the goods delivered or damaged, do not attempt to connect the device to
the mains.
●
Place on a stable surface (on a desk etc.).
●
Use a properly secure.
●
Make sure that all guards and safety devices are properly installed.
●
The saw blade must rotate freely.
●
Check all movable parts of the device to ensure that it is easy to move.
●
Before use, compare the data on the nameplate of the mains voltage.
SET UP AND ASSEMBLY
Your Miter Saw is completely assembled when you receive it. You may wish to attach the
following included accessory items.
1. Dust Collector Bag installs by inserting the bag opening into the outlet on top of the saw casing.
2. The material hold down clamp can be inserted into the two holes on either sides of the guide
fence, and held in place with the thumb screws.
3. The material support brackets may be inserted into the two holes on both sides of the table, and
held in place with the thumb screws.
4. Avoid wet conditions when using electrical equipment.
5. Always inspect power cords and extension cords for damage before use. Never plug in a power
cord that is not in good condition.
