420 774 335 397 www.sharks-shop.cz Stránka 19
PERFORMANCE
Your new welding helmet Spirit 1/1/1/1. Your new welding helmet was developed and made by Steen
QOS, s.r.o. and to meet the demands for high standards, operational reliability, easy operation and
user safety.Stable and reliable performance will provide you with proper care. You will enjoy years of
safe operation, if you use the cordless drill properly and only as intended hobby use.
WARNING
Read these instructions on operation and maintenance before starting work. Pay
attention to all WARNINGS and NOTES.
Yours SHARKS product has many features for ease and speed up work. This
product has been devoted attention to the development of operational safety and
reliability with respect to simple maintenance and operation.
BEFORE WELDING
Check the front cover lens to make sure that they are clean, and that no dirt is covering the two
sensors on the front of
filter cartridge. Also check the front/inside cover lens and the front lens retaining frame to make sure
that they are secure.
Inspect all operating parts before use for signs of wear or damage. Any scratched, cracked, or pitted
parts should be replaced immediately before using again to avoid severe personal injury.
Check for light tightness before each use.
Select the shade number you require at the turn of a shade knob(Seeing the Shade Guide Table
No.1). Finally, be sure that the shade number is the correct setting for your application.
Adjust headband so that the helmet is seated as low as possible on the head and close to your face.
Adjust helmet's angle when in the lowered position by turning the adjustable limitation washer.
WARNlNG
●
This Auto-Darkening Welding Helmet is not suitable for laser welding
＆
oxyacetylene Welding.
●
Never place this Helmet and Auto-darkening filter on a hot surface.
●
Never open or tamper with the Auto-Darkening Filter.
●
This Auto-darkening welding helmet will not protect against severe impact hazards, including
grinding disks. Never use for grinding.
●
This helmet will not protect against explosive devices or corrosive liquids.
●
Don't make any modifications to either the filter or helmet, unless specified in this manual. Don't use
replacement parts other than those specified in this manual. Unauthorized modifications and
replacement parts will void the warranty and expose the operator to the risk of personal injury.
●
Should this helmet not darken upon striking an arc, stop welding immediately and contact your
supervisor or your dealer.
●
Don't immerse the filter in water.
●
Don't use any solvents on filter’s screen or helmet components.
●
Use only at temperatures: -5°C - +55°C
●
Storing temperature: -20°C - +70°C
●
Protect filter from contacting with liquid and dirt.
●
Clean filters surfaces regularly, do not use strong cleaning solutions. Always keep sensors and solar
cells clean using a clean lint-free tissue/cloth.
●
Regularly replace the cracked/scratched/pitted front cover lens.
