3
E
Setting up the PC
To use the touch panel, the touch panel driver must be installed from the supplied CD-ROM and the touch panel must be
connected to your PC.
Installing the touch panel driver
The touch panel driver is a program that enables you to use the touch panel to operate the PC that is connected to the touch
panel.
Caution
• This can only be done by a user with administrator authority.
• If an older version of the touch panel driver is installed, remove (uninstall) the old version before installing the touch panel
driver. (See page 8.)
• If you are using a USB hub, use a self-powered hub (a hub capable of supplying a 500 mA current). The touch panel will not
operate correctly if a bus-powered USB hub is used.
• Do not touch the touch panel when connecting the USB cable.
If you touch the touch panel, this may be detected as an element failure in the infrared transmitter/receiver and malfunctioning
will result. In this case, disconnect and then reconnect the USB cable.
1. Start your PC.
2. Exit all applications that are running.
3. Connect the USB cable for the touch panel to the PC.
After it has been connected, the touch panel will be automatically recognized.
USB cable (Supplied)
To the USB terminal
of the PC
USB port
4. Insert the supplied CD-ROM into the CD-ROM drive of your PC.
5. Open the CD-ROM drive in “Computer” or “My Computer”.
6. Double-click the “TouchPanel” folder.
7. Double-click the install file.
• If you are using a 32-bit operating system, double-click “TPDriverSetup32.exe”.
• If you are using a 64-bit operating system, double-click “TPDriverSetup64.exe”.
• When the “User Account Control” screen appears, click “Yes” (or “Allow”).
8. Click “Next”.
Follow the on-screen instructions to install the driver.
• If the “Windows Security” screen appears, click “Install” (or “Install this driver software anyway”).
• If the “Software Installation” screen appears, click “Continue Anyway”.
• If the “Touch Panel Driver Files in Use” screen appears, click “Continue”.
9. When the installation finished screen appears, click “Close”.
10
. If a screen appears prompting you to restart your PC, click “Yes”.
This completes the installation of the touch panel driver.
Each time the PC is started, the touch panel driver will start automatically to enable the touch panel to be used.
The first time you use the touch panel, perform calibration (position adjustment). (See page 5.)
