UX-A260U
3. 12. Entry data receive
In this mode, the registered data sent from the other machine is receiv-
ed and the received data is registered in the machine. When this mode
is used for receiving, the other machine must be in the entry data send
mode.
After receiving is completed, the following lists are printed.
1. Telephone list data
2. Sender register data (*)
3. Optional setting list (*)
4. Soft switch content
5. Junk fax number list (*)
6. Recording setting list data (*)
(*): Refer to SETUP LIST
2 – 4
Press FUNCTION
9
8
7
START
START
Press FUNCTION key.
Press
key.
Press
key.
Bit1 - 8 are set.
Soft SW-A2 - SW-O6 are set.
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A2 = 0 0 0 0 0 0 0 0
S F T SW-O6 = 0 0 0 0 0 0 0 0
Press
key during setting.
To finish the settings halfway between
SW-A1 and SW-O6, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW No. remain in effect.
The soft switch mode is terminated.
S F T SW-A1 = 0 0 0 0 0 0 0 0
START
DATA No. 1 2 3 4 5 6 7 8
When the COPY key is pressed, the
contents of soft switches are printed.
4. How to make soft switch setting
To enter the soft switch mode, press the following key entries in se-
quence.
3. 13. Flash memory check
Data is written into and read from the flash memory to check data con-
formity. When the unit enters this mode, the check is started.
3. 14. Flash memory clear
Data in the flash memory is cleared (memory clear). When the unit en-
ters this mode, the check is started.
*Operation of hardware and signal in the flash memory check mode and
flash memory clear mode, and the result of check.
The result is announced by the buzzer beeps. The result of check is
printed.
Beeps
0
→
No error
1
→
Memory error
manuals4you.com
manuals4you.com
Summary of Contents for A260 - UX B/W Thermal Transfer
Page 48: ...UX A260U Control PWB parts layout Top side 6 7 manuals4you com manuals4you com ...
Page 49: ...UX A260U Control PWB parts layout Bottom side 6 8 ...
Page 53: ...UX A260U TEL LIU PWB parts layout Top side 6 12 ...
Page 54: ...UX A260U TEL LIU PWB parts layout Bottom side 6 13 manuals4you com manuals4you com ...
