1 – 1
UX-A260U
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviations from these values in individual units.
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Automatic dialing:
40 numbers
Imaging film:
Initial starter roll: (included with
machine): 32 ft. (10 m) (approx. 30
letter-size pages)
Replacement roll (not included):
UX-5CR 164 ft. (50 m) roll (one roll
yields approx. 150 letter-size pages)
Memory size* :
448 KB (approx. 24 average pages
with no voice messages recorded, or 20
minutes of voice message (including
OGMs) with no documents in memory)
Modem speed:
14,400 bps with automatic fallback to
lower speed
Transmission time* :
Approx. 6 seconds
(only when ECM is on)
Resolution:
Horizontal:
203 pixels/inch (8 dots/mm)
Vertical:
Standard: 98 lines/inch
(3.85 lines/mm)
Fine/Halftone: 196 lines/inch
(7.7 lines/mm)
Super fine: 391 lines/inch
(15.4 lines/mm)
Automatic document feeder: 10 pages max. (letter/A4, 20 lb paper)
Recording system:
Thermal transfer recording
Halftone (grayscale):
64 levels
Compression scheme:
MH, MR, MMR
Display:
16-digit LCD display
Applicable telephone line:
Public switched telephone network
Paper tray capacity:
Letter: Approx. 50 sheets (20-lb. copier
paper at room temperature; maximum
stack height should not be higher than
the line on the tray)
Legal: 5 sheets
Recommended paper weight is 20-lb.
Copy Bond
Compatibility:
ITU-T (CCITT) G3 mode
Input document size:
Automatic feeding:
Width: 5.8 to 8.5"
(148 to 216 mm)
Length: 5.5 to 11"
(140 to 279 mm)
Manual feeding:
Width: 5.8 to 8.5"
(148 to 216 mm)
Length: 5.5 to 23.6"
(140 to 600 mm)
Effective scanning width:
8.3" (210 mm) max.
Effective printing width:
8.3" (210 mm) max.
Contrast control:
Automatic/Dark selectable
Reception modes:
TEL/FAX/TAD
Copy function:
Single/Multi (99 copies/page)
Telephone function:
Yes
(cannot be used if power fails)
Power requirements:
120 V AC, 60 Hz
Operating temperature:
41 - 95
°
F (5 - 35
°
C)
Humidity:
25 - 85 % RH
Power consumption:
Stand-by: 3.6 W
Maximum: 100 W
Dimensions (without
Width: 12.9" (327 mm)
attachments):
Depth: 7.6" (193 mm)
Height: 6.4" (163 mm)
Weight (without
Approx. 6.2 lbs. (2.8 kg)
attachments):
*
Based on Sharp Standard No.1 Chart at standard resolution, exclud-
ing time for protocol signals (i.e., ITU-T phase C time only).
justmanuals.com
Summary of Contents for A260 - UX B/W Thermal Transfer
Page 48: ...UX A260U Control PWB parts layout Top side 6 7 manuals4you com manuals4you com ...
Page 49: ...UX A260U Control PWB parts layout Bottom side 6 8 ...
Page 53: ...UX A260U TEL LIU PWB parts layout Top side 6 12 ...
Page 54: ...UX A260U TEL LIU PWB parts layout Bottom side 6 13 manuals4you com manuals4you com ...
