(Main unit operation)
Note:
This product can receive FM stereo/FM monaural and
AM monaural broadcasts. AM stereo broadcasts will not
be played in stereo.
(Main unit operation)
Tuning
1
Set the ON/STAND-BY switch to ON.
Press the TUNER (BAND) button.
Press the TUNER (BAND) button to select the desired fre-
quency band. (FM ST, FM or AM)
Press the TUNING
or
A
) button to tune into the desired
station.
Manual tuning:
Press the TUNING
or
A
) buttons as many times as required
to adjust the frequency shown on the display to the frequency
of the desired station.
Auto tuning:
When the TUNING (v or
button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
Notes:
When radio interference occurs during auto scan tuning, auto
scan tuning may stop automatically at that point.
If a weak station signal is found during auto scan tuning, the
station will be skipped.
To stop the auto tuning, press the TUNING
or
A
) button
again.
To receive an FM stereo transmission, press the TUNER
(BAND) button so that the “ST” indicator on the display lights
will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button
so that the “ST” indicator goes out.
Although the reception changes to monaural, the sound
becomes clearer.
To switch the unit off after use:
Set the ON/STAND-BY switch to STAND-BY.
Note:
The memory recalls the last station received even after
changing the TUNER (BAND) button or function selector but-
tons, or setting the ON/STAND-BY switch to STAND-BY.
Preset tuning
You can store up to 40 stations in memory (40 stations consisting
of any combination of FM and AM stations you like) and recall
them at the push of a button.
To enter stations into memory:
Perform steps
6 in the “Tuning” section.
Press the MEMORY/SET button.
Within 30 seconds, press the PRESET
or
A
) button to
make the preset channel number flash in the display.
Store the stations in memory, in order, starting with preset
channel
Within 30 seconds, press the MEMORY/SET button to store
that station in the selected station preset number memory.
If the “MEMORY” and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
Repeat steps 1 4 to set other preset stations, or to change
a preset station.
11
