48
Using the SPF/RSPF
The SPF/RSPF is designed to hold up to 30 originals measuring from 5-1/2" x 8-1/2"
to 8-1/2" x 14" and weighting from 14 lbs. to 23.9 lbs. (52
g
/m
2
to 90
g
/m
2
).
1
Make sure that no original is left on the original table.
2
Adjust the original guides to the size
of originals.
3
Set the originals face up in the
original feeder tray.
Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the
SPF/RSPF. If the stream feeding mode has been enabled using user program No.4,
the SPF/RSPF (
) indicator will blink approximately 5 seconds after the last
original has been fed by the SPF/RSPF. While this indicator is blinking, any new
originals placed in the original feeder tray will be fed and copied automatically. If the
stream feeding mode has been disabled, the start (
) key must be pressed each
time the originals are set even immediately after completion of a copy run from the
SPF/RSPF. The default setting of the stream feeding mode is "ON". See "USER
PROGRAMS" (p.55).
•
Before feeding originals in the original feeder tray, be sure to remove
any staples or paper clips from them.
•
Before placing curled or wavy originals into the original feeder tray, be
sure to flatten them. If not, original misfeeds may result.
•
The SPF/RSPF (
) indicator on the operation panel will light up. If
this indicator does not light up, the originals are not properly set or the
SPF/RSPF is not properly closed.
•
Badly damaged originals may misfeed in the SPF/RSPF. It is
recommended that such originals be copied from the original table.
•
Special originals such as transparency film should not be fed through
the SPF/RSPF, but should be placed directly on the original table.
•
Image loss (max. 5/32" (4mm)) can occur at the leading and trailing
edges of the copies. Also image loss (max. 11/64" (4.5mm) in total)
can occur along the other edges of the copies. It can be 15/64" (6mm)
(max.) at the trailing edge of the second copy of two-sided copying.
•
To stop continuous copying using the SPF/RSPF, press the clear
(
)
key.
•
Copying using one-sided to one-sided mode (AL-1551CS):
Ensure that no indicator is lit among the original to copy indicators.
Original face up
AL-1215_1530-1551CS.book 48
ページ
２００２年８月７日 水曜日 午前９時３４分
